Project which has 33 floors (1 basement floor, 1 ground floor and 31 floors) was completed successfully by using İNTEVA formwork systems. At the first six floors, the floor heights vary at the intervals of 450 cm and 600 cm. After these six floors, other floor heights were designed as 350 cm up to the 33rd floor. The heights being too variable, which is considered to be a big problem especially for wall formworks, was easily solved as the formwork height is adjustable in İNTEVA formwork system. Elevator and stairs shatfs formworks were designed according to the floor with the height of 550 cm and it was thought that their concrete would be poured at the underfloor level so formwork was given at the height of 525 cm and 1/2 set. By using this formwork, 425, 500 and 525 cm high walls were poured by adjusting
only plywoods’ heights which were mounted in front of the formwork. The 575 cm wall on just one floor was poured 50 cm short and this 50 cm was solved like a beamside during the slab formwork and it’ s concrete was poured with the slab concrete. 525 cm height formwork was assemled by adding 330 and 180 cm height’ s beams and fixing four lines steel wailings behind these beams. At the 360 cm height beams were obtained 325 cm height elevator and stairs shafts formwork which were to be used at these floors were solved by using 2 lines steel wailings. Few 330 cm high beams were added to the remainder components from disassemby and elevators and stairs shafts formworks which were used as 1/2 set at the lower floors were used full set at these floors so project time was shortened. Big struts which were used at the 525 cm height formwork, were divided in two parts and used as two struts at the 325 cm height formwork. This is a very good example for the formwork engineering. Formwork engineering company should use all the components of it’s client properly and efficiently so it provides big benefits to the client’s project like economy, quality and speed.